7KW DUAL-MODE BACKUP GENERATOROperator’s ManualManual del OperarioManuel d’utilisationSAVE THESE INSTRUCTIONSManual No. 200267GSRevision A (06/26/2006
8www.briggsandstratton.comLP Fuel Tank InstallationIMPORTANT: To ensure optimal performance,use two (2) LP fuel tanks during operation.This section de
3. Using a sponge, rag or small non-metallic brush, applythe soap water mixture at each of the locationsshown in Figure 10 below.4. Check each locatio
10www.briggsandstratton.com8. Repeat Steps 2 through 7 until no leaks are detected.DO NOT use the generator if leaks cannot bestopped. Contact a quali
11Generator Controls and FeaturesRead this Operator’s Manual and safety rules before operating your generator.Compare the illustrations with your gene
12www.briggsandstratton.comGFCIMAIN BREAKERPUSHTORESETControl Panel Controls and FeaturesCompare this illustration with your generator’s Control Panel
13Receptacles120/240 Volt AC, 30 Amp, LockingReceptacleThis receptacle (Figure 11) supplies the entire generatoroutput and is protected against overlo
14www.briggsandstratton.comOperating Your GeneratorStarting the EngineUse the following start instructions:1. Make sure unit is on a flat, level surfa
15Ground Fault ProtectionThis unit is equipped with a Ground Fault CircuitInterrupter (GFCI). This device meets applicable federal,state and local cod
16www.briggsandstratton.comDon’t Overload GeneratorCapacityYou must make sure your generator can supply enoughrated (running) and surge (starting) wat
17Maintenance ScheduleFollow the hourly or calendar intervals, whichever occurs first.More frequent service is required when operating in adverse cond
Briggs & Stratton Power Products Group, LLC900 North ParkwayJefferson, WI 53549Copyright © 2006 Briggs & Stratton Power Products Group, LLC.A
18www.briggsandstratton.comEngine parts should be kept clean to reduce the risk ofoverheating and ignition of accumulated debris. Use thesame instruct
19Service Air Cleaner ElementsYour engine will not run properly and may be damaged ifyou run it with dirty air cleaner elements.• Replace the air clea
20www.briggsandstratton.comIMPORTANT: DO NOT use pressurized air or solventsto clean cartridge. Pressurized air can damage cartridge;solvents will dis
21Service BatteryIf it is necessary to service the battery, proceed as follows:1. Open control panel cover.2. Remove the 15 Amp fuse from the control
22www.briggsandstratton.comNotesTroubleshootingProblem Cause CorrectionEngine is running, but no ACoutput is available.1. Circuit breaker open or defe
23Replacement PartsReplacement parts are available from your authorizedBriggs & Stratton Service dealer. Each one carries a stockof genuine Briggs
24www.briggsandstratton.comBriggs & Stratton Corporation (B&S), the California Air Resources Board (CARB)and the United States Environmental P
253. No ChargeRepair or replacement of any Warranted Part will beperformed at no charge to the owner, includingdiagnostic labor which leads to the det
26www.briggsandstratton.comThe warranty period begins on the date of purchase by the first retail consumer or commercial end user, and continues for t
1Table of ContentsSafety Rules...2Equipment Description...
2www.briggsandstratton.comSAVE THESE INSTRUCTIONSSafety RulesThis is the safety alert symbol. It is used toalert you to potential personal injuryhazar
3• DO NOT touch hot surfaces and avoid hot exhaust gases.• Allow equipment to cool before touching.• Keep at least 5 ft. (152 cm) clearance on all sid
4www.briggsandstratton.comEquipment DescriptionRead this manual carefully and becomefamiliar with your generator. Know itsapplications, its limitation
5Ground Fault ProtectionThe generator’s receptacles are equipped with GroundFault Circuit Interrupter (GFCI) protection. This GFCIdevice meets applica
Generator LocationConsider these factors when determining the propergenerator operating location:• Install the unit outdoors on a flat, level surface
7• Install the unit in a location where sump pumpdischarge, rain gutter down spouts, roof run-off,landscape irrigation, or water sprinklers will not f
Komentarze do niniejszej Instrukcji