Briggs & Stratton 100 AMP AUTOMATIC TRANSFER SWITCH Instrukcja Operatora Pobierz pdf (Strona 7)

Power Wiring Interconnections

All wiring must be the proper size, properly supported

and protected by conduit. All wiring should be done per

applicable federal, state and local codes, standards and

regulations. Obey wire type and torque specifications printed

on the terminal blocks and neutral/ground connector.

Complete the following connections between the transfer

switch, main distribution panel, utility power and generator.

Useinstaller-supplied300VACorgreaterwirethatcomplies

with Table 310.16 in the National Electric Code. Apply the

necessary correction factors and wire size calculations.

1. Set generator’s circuit breaker to OFF (open) position.

2. Set generator’s system switch to OFF position and

remove 15 Amp fuse from system control panel.

3. Turn off utility power to the standby generator and

transfer switch.

4. Connect utility service to transfer switch’s utility

disconnect circuit breaker terminals marked

“UTILITY CONNECTION”.

5. Connect utility service neutral to transfer switch

neutral terminal.

6. Connect main distribution panel feeder

conductors to transfer switch terminals marked

“LOAD CONNECTION”.

7. Connect main distribution panel neutral conductor to

transfer switch neutral terminal.

8. Connect main distribution panel ground conductor to

transfer switch “GND” terminal.

Assure grounding electrode conductor is connected and

bonded per applicable federal, state and local codes,

standards and regulations.

9. Connect copper feeder conductors from transfer switch

breaker “GENERATOR CONNECTION” terminals to

generator circuit breaker LINE1 and LINE2 terminals.

Each conductor must pass through hole of current

transformer before making connection.

10. Plug current transformer leads into “CT1” and “CT2”

terminals on transfer switch control board.

11. Connect copper conductor from transfer switch

neutral terminal to generator NEUTRAL terminal.

Observe generator control panel labeling for

terminal identification.

12. Connect copper conductor from transfer switch “GND”

terminal to generator control panel “GROUND” terminal.

Assure generator equipment grounding conductor is

connected per applicable federal, state and local codes,

standards and regulations.

13. Connectthetransferswitch“UTILITY240VAC”

terminalstogenerator’s“240VAC”terminals

usinginstallersupplied300VACorgreater

copper wire, minimum #14 AWG conductors via

two-pole connector supplied with generator.

WARNING Low voltage wire cannot be installed in

same conduit as power voltage wiring.

Failure to follow above warning could cause personal •

injury, damage and/or malfunction of equipment.

NOTICE Improper installation can cause damage to the

circuit boards and shorten their life. Installing circuit

boards in live circuits will damage the board and is not

covered by warranty. ALWAYS disconnect ALL sources of

power prior to servicing.

Remove all power prior to installing this equipment. •

Failure to do so could cause internal damage to the board

when making electrical connections.

Turn generator to • OFF position.

Turn off utility power to the standby generator and •

transfer switch.

WARNING Battery posts, terminals and related

accessories contain lead and lead compounds, chemicals

known to the State of California to cause cancer and

reproductive harm. Wash hands after handling.

240V

120V

Neutral

Ground

To Transfer Switch

Line 1 Neutral

Ground

Line 2

Circuit

Breaker

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Briggs & Stratton 100 AMP AUTOMATIC TRANSFER SWITCH Instrukcja Operatora Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Generatory prądu Briggs & Stratton 100 AMP AUTOMATIC TRANSFER SWITCH