Briggs & Stratton 10000 Watt Home Generator System Instrukcja Operatora Pobierz pdf (Strona 12)

12 BRIGGSandSTRATTON.COM

System Connectors

Except for the power output and grounding connectors, all signal wire connections are made to removable two- or ten-pin

connector plugs. Compare this illustration with your generator to familiarize yourself with the location of these important

connections:

A - 2 Pole Connector Plug

B - 240 Volt Utility — Use to hook up the 240V utility leads

from the transfer switch to the generator.

C - +12 Volt DC, .5 Amp Output — Internal power supply.

D - Remote LED Output — Use this to hook up the remote

LED supplied with the generator. The remote LED will

turn on and off in a series of blinks if certain faults are

detected in the generator.

E - Transfer Switch Communication — Use TxRx and TxRx

GND to transfer switch to monitor transfer switch

functions.

F - Fault Contacts — Use NO, COM and NC to hook up a

siren, light, optional GenAlert, etc. to alert you in case

of a fault. Contacts reverse state (NO goes to NC and

vice versa) upon a fault condition.

G - 10 Pole Connector Plug

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Brak uwag

Briggs & Stratton 10000 Watt Home Generator System Instrukcja Operatora Strona 12